11/22/2023 0 Comments Fortigate site to site vpnSite-to-site VPNs are useful for companies that prioritize private, protected traffic and are particularly helpful for organizations with more than one office spread out over large geographical locations. This could be a corporate network where multiple offices work in conjunction with each other or a branch office network with a central office and multiple branch locations. You can add or restrict the policy address, I'm not going to waste my time writing out an example but the above would get you up.A site-to-site virtual private network (VPN) refers to a connection set up between multiple networks. Now for ANY fwpolicy that you bind to that ipse-vinterface for ipsec,you use that ip nat pool, so the clients are SNAT behind that # now for policy you should create a ip nat pool for the to-be nat'd address of 10.255.12.240 Set keepalive 12 <-adjust KeepAlive as required =other side FGT that has no public-address = # do not forget your policy tied to spoke1-FGT interface, I'm not wasting my time writing a policy example for you # 1st the end side that terminates the 2x public address We don't work for free but here's a basic cfg assume ikev1, assuming your SNAT your lan behind 10.255.12.240 If there is more information needed please advise.įortigate model = Fortigate VM64 (in cloud) v 6.2.3 build 1066 I'm setting up the Fortigate side and the client is setting up the remote peer side. I looked for a step by step setup guide and have not found what I need to successfully setup a working tunnel with NAT. Below is the information about the Fortigate and VPN tunnel. I am trying to setup a new site to site VPN with NAT involved and I am new to the Fortigate firewall. I'll start by saying I am new to Fortigate products.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |